Magnesium Aluminum Alloy Powder

Magnesium Aluminum Alloy Powder Application: Fireworks Content ratio: according to your request Delivery time: 15-20 days

Magnesium Aluminum Alloy Powder Application: fireworks or metallurgyAppearance: gray powder with metallic luster

Content ratio: according to your requestPackage: 100kg/ iron drum

Delivery time: 15-20 days

Characteristic

The aluminum magnesium metal alloy powder burns easiest, producing the heat with sending out the dazzling and white light, this characteristic is extensive to used for the armament industry, such as manufacturing the flare, signal plays with napalm bomb etc..In firework industry, the aluminum magnesium metal alloy powder gives out light essentially.Because of its chemistry kind alacrity, in metallurgy industry it is used to take off oxygen, an additive, purifying, fire-proof material etc.

Magnesium alloys are mixtures of magnesium with other metals (called an alloy), often aluminium, zinc, manganese, silicon, copper, rare earths and zirconium. Magnesium is the lightest structural metal. Magnesium alloys have a hexagonal lattice structure, which affects the fundamental properties of these alloys. Plastic deformation of the hexagonal lattice is more complicated than in cubic latticed metals like aluminum, copper and steel. Therefore magnesium alloys are typically used as cast alloys, but research of wrought alloys has been more extensive since 2003. Cast magnesium alloys are used for many components of modern cars, and magnesium block engines have been used in some high-performance vehicles; die-cast magnesium is also used for camera bodies and components in lenses.

Magnox (alloy), whose name is an abbreviation for 'magnesium non-oxidising', is 99% magnesium and 1% aluminium, and used in the cladding of fuel rods in some nuclear power stations.

Magnesium alloys tend to be referred to by short codes (defined in ASTM 275) denoting the approximate chemical composition by weight: for example, AS41 has 4% aluminium and 1% silicon; AZ81 is 7.5% aluminium and 0.7% zinc. If aluminium is present, manganese is almost always also there at about 0.2% by weight to improve grain structure; if aluminium and manganese are absent, zirconium is usually present at about 0.8% for the same purpose.

Aluminium alloys are alloys in which aluminium (Al) is the predominant metal. The typical alloying elements are copper, magnesium, manganese, silicon and zinc. There are two principal classifications, namely casting alloys and wrought alloys, both of which are further subdivided into the categories heat-treatable and non-heat-treatable. About 85% of aluminium is used for wrought products, for example rolled plate, foils and extrusions. Cast aluminium alloys yield cost effective products due to the low melting point, although they generally have lower tensile strengths than wrought alloys. The most important cast aluminium alloy system is Al-Si, where the high levels of silicon (4.0% to 13%) contribute to give good casting characteristics. Aluminium alloys are widely used in engineering structures and components where light weight or corrosion resistance is required.

Alloys composed mostly of the two lightweight metals aluminium and magnesium have been very important in aerospace manufacturing since somewhat before 1940. Aluminium-magnesium alloys are both lighter than other aluminium alloys and much less flammable than alloys that contain a very high percentage of magnesium.

Aluminium alloy surfaces will keep their apparent shine in a dry environment due to the formation of a clear, protective layer of aluminium oxide. In a wet environment, galvanic corrosion can occur when an aluminium alloy is placed in electrical contact with other metals with more negative corrosion potentials than aluminium.

Aluminium alloy compositions are registered with The Aluminum Association. Many organizations publish more specific standards for the manufacture of aluminium alloy, including the Society of Automotive Engineers standards organization, specifically its aerospace standards subgroups, and ASTM International.